CD Library - Troubleshooting Page 3

CD Library Troubleshooting

Home | CD Library > Troubleshooting

Page 1 2 3

3. Advance adjustment

Sometimes the sensor may out of align and it may cause malfunction problem, too. Then user need to do more adjustment on PCD board.

Step 1 Do same 1-5 steps in previous instruction. Then take off the black cover board above the PCD board.	Step 2 Loose the two screws on the PCD board.
Step 3 Take off the PCD board and turn to the other side.	Step 4 The SB3 sensor is out of align now. User needs to move the black sensor by gently push on the bottom of sensors till the SB3 white line is just fully covered by the sensor.
Step 5 User can see the white line covered by sensor.	Step 6 Re-tight the screw, Then sensor adjustment is done.

Then following the previous the 15-18 steps, you can complete whole adjustment. And it makes CD Library work again.

*If above steps can not resolve your problem. please contact us via email or call us at (630)226-9987. However, before you ask technical support, please email us your contact information, when and where you get the CD Library. We also require you to fax us your original purchase invoice or receipt in order to provide our best service.

Page 1 2 3